Robert

Can I manually move the machine to a set point without using the jogging buttons?

Hi, We recommend attaching it to your WorkBee, the hardware to do this is supplied, and the guide steps are here: 1. Final Assembly

Hi Nicky, Have you installed the WorkBee drivers?

Hi James, If you send an email in, we can issue a replacement

Hi Nick, Thanks for your message. There should be no password. Can you send a screenshot of where it is asking for the password please?

Hi, Have you got the Carveco post processor installed here: WorkBee Firmware Releases

Hi Mark, Thanks for your message. Could i get more details about the error message you are getting?

Hi Paul, Thanks for your message. With V Carve bits you cannot probe the X/Y so that value does not matter. You can only probe the Z, which does not need that value

Hi Julien, Thanks for your message. Normally adjusting the eccentric spacers fixes this. Try adjusting them using this method: - Set all the eccentric spacers to their widest position - Slightly loosen the bolts holding wheels on the aluminium spacer side - Adjust the eccentric spacers so all the wheels (both sides) are slightly touching the extrusion. - Tighten the bolts holding wheels on the aluminium space side - Check the eccentric spacers so all the wheels (both sides) are slightly touching the extrusion.

Hi, I am afraid it only sets the Work X and Y, not adjust the X-Axis and Y-Axis to account for material skew.

Hi Alan, Thanks for your message. No, the tool diameter is not taken into account in the outside machine limits error.

Hi James,

You can try through the mobile hotspot, but does always work.

You could try it in access point mode, where the machine creates its own wifi network.

Hi Mark,

Did you buy your machine off us, and how long ago, as potentially you are following the wrong manual

You can communicate with the board two ways outside of the Web Control HTTP requests or using Telnet.The source code for WorkBee Control can be found here: https://github.com/Ooznest/WorkBee-Contr...

To see how the HTTP requests are completed, start by looking at the PollConnector.js file.

There is a forum post about connecting via Python using Telnet here: https://forum.duet3d.com/topic/27396/bas...

Hi Colin,

Yes button head bolts use in replacement of the low profiles bolts

Thanks

Hi Gary,

Yes, on this step we are using the threads on the ends of the extrusion to secure the pieces.

Hi,

There is an issue with your plate. Please contact us to replace it.

Hi Theo,

Do not use the estop to turn off the machine, switch it off at your wall socket.

Hi,

There is no restriction on this, you can mount it how you want.

Hi,

Sorry about this, I believe a replacement is already on its way to you.

Hi Mark,

The mount she be on the opposite side of the wheels.

Thanks.