My round holes are not coming round
3 Answers
What is the purpose of the Calibration Endmill?
accepted 2 Answers
Fans on the duet board housing.
2 Answers
Adjusting eccentric spacers on Y-axis after assembly complete?
accepted 1 Answer
Stage 4, X-Gantry assembly
discussion 1 Reply
Y plate wheel adjustment.
1 Answer
First couple of passes not engaging with material
discussion 2 Replies
At what point do I change the tool when there are multiple tool paths?
discussion 2 Replies
Instruction pictures not loading
2 Answers
I have made a mess of the upgrading, I need a original sd copy
accepted 2 Answers
after firmware upgrade - cannot home Y axis
accepted 2 Answers
whats the different gcodes
discussion 1 Reply
Changing z during job
accepted 2 Answers
crude contours after finishing pass
accepted 1 Answer
How do I change access point
1 Answer
Not cutting square/flat bottom
2 Answers
Max Feed Rate for Z1+
2 Answers
Best bit for cutting 1.2mm thick Hylite?
accepted 1 Answer
Touch Probe Outside Machine Limits
discussion 1 Reply