Setting up first job
5 Answers
How much does the spindle on the Z axis raise?
discussion 1 Reply
Update from Firmaware 1.0.1
accepted 1 Answer
Endstop / Limit switch issue after firmware update
accepted 1 Answer
Is XYZ Lead Screw Or Ball Screw?
accepted 1 Answer
Toolpath errors when cutting
1 Answer
keep getting the following error message
2 Answers
Settings for Ooznest Solid Carbide Engraver – 2 Flute
discussion 1 Reply
X axis homes in wrong direction
discussion 4 Replies
workbee z1+ lost connection
1 Answer
Ethernet connection lost following disconnection
accepted 3 Answers
Increasing Z axis travel
accepted 1 Reply
motor phase A may be disconnected reported by driver(s) 1
discussion 1 Reply
Ethernet to USB adapter
1 Answer