Wire routing improvements planned?
1 Answer
WorkBee Duet Wifi vs Ethernet
accepted 1 Answer
1500 x 1500 spoil board sourcing
1 Answer
The WorkBee is connected to Wifi, but WorkBee Control will not load?
accepted 1 Answer
Stand alone CAM options? Browser based?
unanswered 0 Answers
The IP Address on my WorkBee keeps changing?
accepted 11 Answers
CNC Laser and Lightburn
discussion 8 Replies
Workbee Z1 loss of power
7 Answers
Dimensions mismatch Pocket / Contour
accepted 7 Answers
new duet 2 wifi controller which guide do I use
accepted 7 Answers
Screw Conversion Fail Help!
discussion 6 Replies
Recurring same size cut on the X axis giving different measurements
accepted 5 Answers
Setting up first job
5 Answers
Z position after corner probing 10mm above where it should be
discussion 5 Replies
Upgrade problems on a windows 11 laptop
4 Answers
X axis homes in wrong direction
discussion 4 Replies
Workbee Hardware Revisions List?
accepted 4 Answers
Offset Difference between TouchProbe and Center marks
accepted 4 Answers
Very weak access point signal
3 Answers